Water Recycle Systems
WRS 32 Water Recycle System Specifications
The WRS 32 Recycle System is designed to solve your wash water disposal problems. This completely automatic treatment system will collect your dirty, oily wash water and process it so that it can be reused in your washing operation. The feed pump transfers the dirty water from a collection sump to the treatment unit. Reagents are added to the water to kill bacteria and odours, neutralize the pH, and remove pollutants such as oil, grease, dirt, and sludge. These reagents, which are commonly used in drinking water treatment, actually make the water much more environmentally friendly and less hazardous for personnel doing the washing. The treated water is then stored until needed for washing. The WRS 32 treats up to 8 gpm (12000 gpd), which is more than enough for most washing operations. This unit is equipped with many convenience features, including automatic priming valves for the reagent pumps, integral water storage tank, and filters status pressure gage. It comes completely assembled and wired, ready to be set in place and plugged into a 15 amp, 115 volt outlet. The water discharge from the integral storage tank is pressurized to feed your pressure washers, even if they are remotely located. Premium components and quality construction ensure the most trouble-free operation possible.
Specifications
Rated flow:
Up to 8 gpm (12000 gpd)
Electrical requirement:
115 VAC, 60 Hz, 1 phase, 15 amp total.
Recycle feed pump:
Self-priming centrifugal cast iron pump with 1/2 HP thermally protected motor. Mounted on the machine base. Controlled by float switch in collection pit. Suction line strainer and foot valve are provided.
Discharge pump:
High head centrifugal pump with 1/2 HP thermally protected motor. Provides pressurized water flow to pressure washer and other uses.
Electrical controls:
High head centrifugal pump with 1/2 HP thermally protected motor. Provides pressurized water flow to pressure washer and other uses.
Reagent metering pumps:
High head centrifugal pump with 1/2 HP thermally protected motor. Provides pressurized water flow to pressure washer and other uses.
Inlet strainer:
Large size with stainless steel screen in corrosion resistant plastic housing.
Filter system:
Two 20" long 20 micron filter cartridges for final polishing. Two sets included.
Sludge collection system:
Three large, disposable fabric socks collect sludge. Two sets included with machine.
Make-up water:
100 psi maximum pressure. Automatically added as required by application.
Recycle tank capacities:
Coagulant tank- 120 gallons
Separator tank- 120 gallons
Storage tank- 120 gallons
Total water capacity- 360 gallons
Recycle construction:
Heavy duty polypropylene tank with unitized construction. Schedule 80 PVC pipe used throughout. Heavy steel base assembly.
Connection sizes:
Machine inlet- 1 1/2 MNPT
Treated water outlet- 3/4 FNPT
Drain line- 1 FNPT
Make up water- 1/2 FNPT
Overall dimensions:
7 ft 6 in long, 3 ft 2 in deep, 4 ft 3 in tall
Shipping Weight:
800 pounds
Options:
Second pH adjusting pump. Additional treated water storage capacity. Sand filter final polishing system. Activated carbon water polishing systems. Ozone treatment. Pre-treatment systems, oil skimmers, and oily water separators.
