Oil Water Separators
OILY WATER SEPARATORS WITH STAINLESS STEEL HOUSINGS
Housing construction is stainless steel (SS) for the premium type. Components are high quality and the separators are designed for long, trouble-free service life. Maintenance required is minimal, but it is important that it be performed to ensure proper operation. Separation means is by polypropylene bead packs. Dual bead packs are provided for the premium units. Dual element sensing probes are utilized to more positively determine the oil level and discharge the oil when necessary.
APT-4-SS OILY WATER SEPARATOR SPECIFICATIONS
Rated flow:
4 gpm (5800 gpd)
Principle of operation:
Oily water separation to 15 ppm via enhanced gravity and large coalescer bed.
Capacity:
Oils with up to .96 specific gravity, 0 to 100% concentration. Temperature 33 to 120F degrees ambient.
Suction:
25 ft. maximum vertical suction lift, less than 15 ft recommended.
Discharge pressure:
15 psi at 4 gpm, 50 psi maximum at 2 gpm.
Oil:
30 ft. maximum vertical discharge, 3 gal. approximate per batch.
Tank construction:
Stainless steel 305, continuously welded.
Internals:
Single, large coalescer bed, polypropylene beads.
Electrical requirement:
115 VAC, 60 Hz, 1 phase. 15 amp protected circuit reqd.
Pump:
Model 332 progressive cavity pump.
Motor:
1/2 hp, 1750 rpm, TEFC
Valves:
Bronze solenoid, gate, pressure relief (30 psi)
Pipe:
Brass with NPT threads.
Controls:
JIC enclosure, dielectric interface sensor with 2 tip sensitive probes.
Connection sizes:
Inlet: 1 1/4 NPT
Backflush recirculate: 3/4 NPT
Oil Discharge: 3/4 NPT
Blackflush inlet: 3/4 NPT
Blackflush water: 30 psi maximum
Overall dimensions:
Less than 27" x 27" x 40" tall
Weight:
Dry: 270 lbs.
Wet: 360 lbs.