Oil Water Separators
OILY WATER SEPARATORS WITH PVC HOUSINGS
Housing construction is polyvinylchloride (PVC) for the utility type. Components are high quality and the separators are designed for long, trouble-free service life. Maintenance required is minimal, but it is important that it be performed to ensure proper operation. Separation means is by a polypropylene bead pack. Dual element sensing probes are utilized to more positively determine the oil level and discharge the oil when necessary.
APT-4-P OILY WATER SEPARATOR SPECIFICATIONS
Rated flow:
4 gpm (5800 gpd)
Principle of operation:
Oily water separation to 15 ppm via enhanced gravity and large coalescer bed
Capacity:
Oils with up to .96 specific gravity, 0 to 100% concentration. Temperature 33 to 120F degrees ambient.
Suction:
25 ft. maximum vertical suction lift, less than 15 ft recommended.
Discharge pressure:
15 psi at 4 gpm, 50 psi maximum at 2 gpm.
Oil:
30 ft. maximum vertical discharge, 3 gal. approximate per batch.
Tank construction:
PVC material, continuously welded.
Internals:
Single, large coalescer bed, polypropylene beads.
Electrical requirement:
115 VAC, 60 Hz, 1 phase. 15 amp protected circuit reqd.
Pump:
Model 332 progressive cavity pump.
Motor:
1/2 hp, 1750 rpm, TEFC
Valves:
Bronze solenoid, gate, pressure relief (30 psi)
Pipe:
Brass with NPT threads.
Controls:
JIC enclosure, dielectric interface sensor with 2 tip sensitive probes.
Connection sizes:
Inlet: 1 1/4 NPT
Backflush recirculate: 3/4 NPT
Oil Discharge: 3/4 NPT
Blackflush inlet: 3/4 NPT
Blackflush water: 30 psi maximum
Overall dimensions:
Less than 27" x 27" x 40" tall
Weight:
Dry: 270 lbs.
Wet: 360 lbs.
